1 E1 to 1 FE Converter HY-C1E1F

Overview

This interface converter provides one unframed 2048K E1 interface and one Ethernet interface to achieve 10/100Base-T Ethernet data transmission on the E1 channel. It is a high performance, self-learning Ethernet bridge. This device is the extension device of Ethernet, using network (PDH/SDH/Microwave) that provide E1 channel to achieve local and remote Ethernet interconnecting with serial interfaces at a lower cost. The device has inter-set loop test function to facilitate the project launching and daily maintenance.

Features

• Based on self -copyright  IC
• Support unframed mode (2048K) set and can manage the remote device condition ,

OAM management data did not take up user’s timeslot

• Have the function of E1 interface loop back check, avoid the converter crashed because of interface loop back;
• Have indicator when the device is power-off or E1 line is broken or lose signal;
• Can set the E1 line that not to send the LINK signal to Ethernet interface while E1 line is broken;
• The Ethernet interface supports jumbo frames (2036 Bytes);
• Inter-set dynamic Ethernet MAC address (4,096) with local data frame filtering
• Ethernet interface supports10M/100M, half/full duplex auto- Negotiation and AUTO-MDIX(crossed line and straightly connected line self-adaptable );
• Have Ethernet monitor self-reset function, the equipment will not dead
• Can achieve the remote device setting any 5 mode of Ethernet and can closed the AUTO-MDIX function;
• Provide 2 clock types: E1 master clock and E1 line clock;
• The local device can forced the remote device rate follow it(when the device is unframed mode, that is invalid);
• Have three Loop Back Mode: E1 interface Loop Back (ANA)、Ethernet interface Loop Back(DIG)、Command the remote,Ethernet interface Loop Back(REM)
• Provide 2 impedances: 75 Ohm unbalance and 120 Ohm balance;
• Support SNMP Network Management;
• Can realize monitor of remote equipment temperature and voltage from local equipment;
• Can form the structure: Ethernet E1 Bridge(A)－－-E1 Optical Fiber Modem(B)－－-Ethernet Optical Fiber Modem (C)
• Can form the structure: Ethernet E1 Bridge(A)－－-Optical Ethernet Modem(B)－－-Ethernet Optical Fiber Transceiver (C),can manage (B) and (C) at (A)

Parameters

• E1 Interface

Interface Standard:           comply with protocol G.703;
Interface Rate:                  n*64Kbps±50ppm;
Interface Code:                 HDB3;

E1 Impedance:                  75Ω (unbalance), 120Ω (balance);

Jitter tolerance:                In accord with protocol G.742 and G.823

Allowed Attenuation:        0~6dBm

• Ethernet interface(10/100M)

Interface rate:                          10/100 Mbps, half/full duplex auto-negotiation

Interface Standard:           Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)

MAC Address Capability:  4096

Connector:                        RJ45, support Auto-MDIX

• Working environment

Working temperature:             -10°C ~ 50°C

Working Humidity:                   5%~95 % (no condensation)

Storage temperature:                     -40°C ~ 80°C

Storage Humidity:                           5%~95 % (no condensation)

Specifications